N I P P L E M EN I N T ' L
The NIPPLE ACADEMY
Chapter 4. 2 Nipple Size Retention -
Nylon Cord Binding
Another method for keeping nipples pumped-up after using suction devices - is 3-ply nylon cord. A couple nipple friends introduced me to the procedure. and after using it for four years or so with good results, I'd like to pass the procedure on to you. It may not be something you'll use everyday, but yet another NIPPLE TURN-ON to use as you desire...
The first "ingredient" is a pair of full-size, inch-long NIPPLES!! (I'm excited, you say??) I realize this an advanced technique - but what the HELL - nothing ventured- nothing tied up!!
The 3-ply nylon cord I use is white, has a sheen to it, and comes in spools of a hundred or so feet.. (You'll have plenty left over - unless you have HUMONGOUS NIPPLES!) - but I'm sure you'll find some other use for it, as well!!
The spool of cord looks like this:
The diameter of the cord is approximately the size of the wire in a coat hanger - and, since it is braided - it has a ridged surface which helps keep it from pulling back on itself as you wind it around your nipples. (Please - one nipple at a time.. unless you're into the full body wrap... A Hah.. we've found another use for the other 98 feet!!)... You should be able to find it at.....YES... WalMart.. in the same section as clothesline cord, and other cords and ropes. (YES - I know your shopping cart is getting full by this time, but I know you'll find room!!)
To begin - put your suction cups on your NIPPLES for the maximum length of time. As they're sucking away - cut two 33-inch lengths of the cord. You will notice that the three thin strands will immediately start of unravel, so don't handle them much. To keep them from unraveling you will need to either tie knots at each end (thanks to my Atlanta buddy) - or burn each end of the nylon strands with a match or other small flame so they seal themselves together. BE VERY CAREFUL!! The nylon will ignite and the melting nylon will stick to and BURN anything it touches!! ** I've found it helps a lot if you have a small container of water handy.. so.. after the ends have burned a few seconds... you can dip them in the water.. and you don't have to worry about the burning hot nylon adhering to you lips... or other body parts!!
Now that the four ends have been sealed we are ready to proceed. Just prior to begin tying them, be sure each nipple is free of saliva or lubricant by taking the cup off, quickly wiping them clean, then putting the cups back on. This will help eliminate the cord from slipping off the NIPPLE as we bind it!! As with the suede lacing procedure in the last chapter, make a simple loop in the CENTER of one of the strands of cord and slip the loop over your yellow suction cup WHILE THE CUP IS STILL SUCKING YOUR NIPPLE, keeping the crossover of the cords at the bottom or underside of your cup. Move the loop down to the end nearest your pec, and begin to tighten the cord snugly around the bottom of the cup as you carefully work the cord off the back of the suction cup, trying to catch as much of your NIPPLE in the loop as you tighten it. (You may need to try several times to get this to work. At first I didn't think it was possible either!! It still may not work if your NIPPLES aren't quite large enough. They have to be large enough so that when you pull the cord tight - the NIPPLES swell up enough to touch the insides of the cups, and thus keep the suction as long as possible. )
This is what it will look like at this stage of the procedure...
Once you get this first loop pulled nice and tight, take one end of the cord and pass it over and completely around the base of your NIPPLE - which is still being sucked into the cup, trying to place it on the INSIDE (next to your pec) of the first round of the cord - until this cord is back at the bottom where you started.. (I know - it's going to be by feel since your nipple is still in the cup .. but you'll be able to tell what's going on in a few tries.) Now pull it and the other cord in opposite directions until the one you just wrapped around your NIPPLE is firmly seated.. Now take the OTHER end of the cord.. and GOING IN THE OPPOSITE DIRECTION - run it up and around your NIPPLE- once again placing it on the INSIDE of the two cords now on your NIPPLE and tighten it as you did the first.
Repeat this up-over-tighten" sequence (about 4 or 5 times) with each end of the cord until you have about 6 inches of cord left on both ends. If you're lucky - you still have suction on your nipple. Now make a simple loop with the two ends, and as you tighten the loop, guide it next to your pec...behind all the other layers of cord... AND... remove the cup and gaze at your FAT, HARD NIPPLEHEAD - standing out from your pec..with the several layers of cord binding it at the bottom!! Repeat the procedure on your other NIPPLE and ENJOY!! As the "pump" starts to recede pull on the cord ends. Since there are no knots they will tighten nicely around your nipples. AS WITH ANY CONSTRICTION - GIVE THEM A BREATHER AFTER 10 - 15 MINUTES - before they start to turn blue!!
Here's what they'll look like.....
So... off to your new adventure.....Happy Binding!!
Ahead to >>>
Nipple Size Retention - Rubber Baby Bottle Nipples
In case you'd like to return to my HOME page >> HOME PLEASE