(My nipples before I start the procedure.)
I'd like to share with you a new technique I've developed.!!
First I use the yellow suction cups for 45 minutes.. or so.
Next, I use my home-made medical suction syringes. ( See Chapter 2.3 -
Medical Syringes - in the Nipple Academy articles).
Before I put the syringes on I slip small rubber rings (cut from the
nipple head of rubber, baby bottle nipples) onto the end of the syringes.
I then put the syringes on my nipples, which are easily sucked in!!
The syringes must be only on the nipples for a few seconds, or just as long
as it takes to get a good suction on the nipples.
Once there is a good seal and my nipples are sucked into the syringes, I
push the rubber rings off the end of the syringes and onto my nipples, and
remove the syringes. And...this is the result!!
By using the syringes the nipples are longer and thinner and the rubber
rings fit more securely. I've always had problems trying to tie my nipples
with cord, and it is not possible to fit a rubber ring around the big suction
cups. Also, with the nipples larger in diameter, the rubber easily falls
off. But with the syringes the nipples are very long and smaller in diameter
so it is easier to attach the rubber rings and have them hold!!
One important point regarding the rubber rings.. I have a little problem
with the nipples being easily injured. - If the rubber is wide, the nipples
lose the pumping effect very fast; but if they are too tight, then I easily end
up with my nipples oozing water drops and even some blood at times.
So it is still not perfect, but I am working on it!
Ps. I have found the yellow snake bit kits.. but they are $9 here for each pair. Not very cheap!! Too bad they don't last very long. I guess they are not made for frequent use!!
(NippleDad's note: BRAVO for the report and the photos..!!)
Ahead to - Nipple Size Retention - "O" rings